YOUR ENGINEERING TOOLKIT

What would you like to calculate?

Find a tool and go directly to its calculation page.

11 available calculators

COPPER WIRE · MECHANICAL TARGETS

Copper Annealing Calculator

Enter copper diameter, target elongation and tensile strength to find matching tested speeds and annealing voltages.

Your wire & required properties

Results update when you change a value.

Matching tolerances Diameter, elongation & strength

Both mechanical properties must fall within these target ranges. Zero tolerance means an exact recorded value.

Energy for your production run

Speed, voltage & energy

Enter targets

Production test data required

Add measured production tests to connect diameter and mechanical properties to speed and voltage. No test data has been supplied with this calculator.

Download test-data template ↓

Import tests in Annealing admin →

Line speed
— m/min
Annealing voltage
— V
Electrical power
— kW
Energy per 1,000 m
— kWh
How the matching and energy calculation work

Same setup, measured properties

Only recorded test runs are matched. Results are not interpolated between diameters, machines or material conditions. The first match is the fastest recorded run inside all selected tolerances; it is not a predicted maximum production speed.

A profile identifies the machine, copper grade, drawing history, cooling setup, elongation gauge length and voltage measurement basis. Use a separate profile when those conditions change.

Required energy

Energy (kWh) = measured power (kW) × length (m) / speed (m/min) / 60

Energy is calculated from the selected run’s measured active input power and speed. It assumes steady running; it excludes startup energy and loads outside that power measurement.

If a test has no measured active input power, its speed and voltage can still be shown, but its energy remains unavailable.

Open separate thermal voltage / energy estimate →